Plastic melt flow indexer digital melt flow rate tester for plastic is used for measuring a variety of plastics, resins during viscous flow condition under a certain temperature and load, to get MFR value per 10min by standard die melt flow rate. It applies to the higher melting temperature of polycarbonate, aromatic sulfone, fluoro plastic, nylon and other engineering plastics, and also used in the plastic test for polyethylene (PE), polystyrene (PS), polypropylene (PP), ABS resin, polyoxymethylene (POM), polycarbonate (PC) resin and of lower melting temperature, which is widely used in plastics, plastic products, petrochemical industry and related universities, research institutes, and commodity inspection departments.
Melt Flow Index Tester is used to determine melt-mass flow rate (MFR). Melt-Volume flow rate (MVR) and melt density of thermoplastic resin. It is applicable not only to the higher melting temperature, such as polycarbonate, nylon, Fluoro plastics, poly oxide and other engineering plastics, and it also applies to plastic measurement of melt lower temperature, such as polyethylene, polystyrene, polypropylene, ABS resin, poly formaldehyde resin. At the same time, it is widely used in plastics raw materials products, the petrochemical industry and related universities, scientific research institutes, and commodity inspection departments.
