Plastic pipe pressure burst test machine maintenance:
1, the device is only suitable for water, is strictly prohibited for corrosive additives;
2, after each boot should be preheated 10 minutes until the system is stable before they can proceed to the next operation;
3, the water level inside the tank can not be higher than the upper edge of the outlet of the circulating water tank;
4, when the test requires high temperature, please cover the tank cover, so as not to hurt the staff;
5, to change the water tank often to maintain the cleanliness of the water tank;
6, equipment failure needs repair, the corresponding pipeline pressure must be removed, during maintenance;
7, If the equipment is not working, hang the plastic pipe which is immersed in the water tank to keep the joint dry;
8, to the sample pressure, the pressure should be gradually pressed in a certain order, only when the normal way on the sample, the pressure system is stable, before they can start to the next sample pressure.
