Falling Mass Impact Tester
As we all know, logistics and transportation is the last mile of quality assurance of precision instruments. However, manufacturers in this link are generally unable to directly control. When transporting, there are often phenomena such as rough loading and unloading, over-stacking (heavy pressure), rain in the open air, loss of accessories, etc. The user receives the damaged instrument and causes damage to the manufacturer and the user.
How to avoid this phenomenon? Enhancing the strength of the instrument and packaging protection is the only way. How to verify the strength of the instrument and packaging protection?
Falling Mass Impact Tester's drop test is an effective verification method. The drop test is a test method in which the packaged instrument is lifted to a certain height multiple times and then free to fall to the ground to see the tolerance of the
Falling Mass Impact Tester.In order to carry out the drop test, Zhongshi Instrument designed the
Falling Mass Impact Tester and established a special drop test chamber. Each type of instrument was subjected to a drop test to verify the strength of the package, the effectiveness of the filler, the structural strength of the instrument, etc. .
Data analysis is important after the drop test. We recorded some of the problems in the packaging, filling, and instrument structure found in the drop test, analyzed one by one, and strengthened the structure of the instrument against the problems that occurred, and reinforced on the package to increase the amount on the filler. At the same time, it is protected from rain and moisture, single-piece protection for small parts and inflatable filling of plastic bags. These measures avoid the damage that may be caused by the actual transportation, and ensure the instrument's unqualified rate of 100%.
